AP250L(oil)
Improved productivity in the superfine and super-precision screw-less drive and new power supply unit
* The picture shown may slightly differ from the actual machine.
Main Features
- Screw-less drive + gantry type construction
- This machine uses a linear motor drive which realizes high speed and fast response and also a low center of gravity gantry-type column, enabling the mechanical displacement due to mass motion to be reduced to the minimum possible, and also realizing greatly improved positioning and machining accuracy.
- Newly developed power supply unit
- The new power supply unit employs 5th generation EDM "Perfect Active Control" technology. It also uses 1 Gbit/sec serial communication technology, realizing high-speed processing of discharge control and motion control simultaneously.
- Improved workability and operability
- This machine comes with a three-sided automated vertical sliding machining tank, a U-shaped work stand, and other parts, resulting in greatly improved workability during setup process. In addition, the operation panel is separate from the machine, which enables all work to be performed from the front of the machine.
Automation System Special Site
Movie
Products
Work tank inner dimensions W x D (mm) | 895 x 740 |
---|---|
Axis stroke X×Y×Z (mm) | 250 x 150 x 120 |
U x V axis travel (mm) | 35 x 35 |
Max. taper angle | ±7°(plate thickness:100mm) |
Max. workpiece dimensions(During flushing machining) W x D x H (mm) | 400 x 270 x 100 |
Max. weight of workpiece(During flushing machining)(kg) | 80 |
Wire electrode diameter (mm) | 0.03 ~ 0.2 *1 |
Wire tension (N) | 3 ~ 18 |
Maximum wire feed rate (mm/sec) | 250 |
Distance from floor surface to upper surface of table (mm) | 1080 |
Machine tool dimensions W x D x H (mm) | 1860 x 2515 x 2105 *2 |
Machine installation dimensions W x D (mm) | 2575 x 3505 |
Total unit weight(kg) | 3730 *3 |
Total power input | 3-phase 50/60Hz 10 kVA |